Connect IM100/IM600 tablet and VCI with vehicle
Select IMMO function>Nissan->System selection->Immobilizer/Smart system->Immobilizer/Smart system->When performing key registration->Register/Erase key
Insert ignition key into ignition key cylinder and switch ignition to ON position
This procedure erases all registered key ID.Therefore,all of the customer's keys should be obtained
before starting this procedure
Perform key registration. Operate according to the following procedures.
1:Remove inserted ignition key fruni ignition key cylinder.
2:tnsert unregistered ignition key into ignition key cylinder, turn ignition switch to the ON position, and then wait for 5 seconds or more.
3:Check that security indicator blinks 5 times.
4:Turn ignition switch to the OFF position, remove ignition key, and then wait for 3 seconds or more.
5:A maximum of 5 ignition keys can be registered by repeating procedures from step 2 to step 4 using unregistered ignition keys. Touch OK to end OtoSys IM100 key registration mode.
Complete Registration Key.
After key registration operation, the system returns to key registration mode. Therefore, it is necessary to end operation. Operate according to the following procedures.
1:Insert ignition key into key cylinder and turn ignition switch to the ON position.
2:For models with remote control engine starter, buzzer of remote control engine starter sounds once. Registration unsucsessful if buzzer does not sound or sounds 3 times.
3:Turn ignition switch to the OFF position, remove ignition key, and then wait for 3 seconds or more.
4:Check that security indicator blinks at intervals of approximately 3 seconds.
Operate according to the following procedures.
1:Check that each of all registered key can start engine. Touch [End].
For remote control engine starter, check operation according to remote control engine starter installation manual.
Succeed.
http://www.obdii365.com/
If you need IM600, please contact :
Email: Sales@OBDII365.com
Skype: OBDII365.com
No comments:
Post a Comment