Download and Flash Autel IM608 II Tablet Firmware

 If your Autel MaxiIM IM608 II/IM608 Pro II tablet is stuck on the boot logo or stuck on the shutting down interface, you can do a firmware reflash. 

NOTE: The firmware reflash will reset IM608 II to factory setting. 

 

Where to download IM608 Pro II reflash file?

The flash file is huge (3.5G). Contact www.obdii365.com customer service to download the flash file.

 

How to Flash Autel IM608 Pro II Firmware?

 

Please try to follow step: 1, 3, 4 to flash the device first.

If it still does not work, try to follow step:2,3,4 to flash the device

 

1. Steps to enter burning mode with TF card:

1). Copy the “dv2123”folder to the TF card to the root directory of the TF card,.

2). Insert the TF card into the tablet, then restart the tablet, the tablet will automatically enter the burning mode.

3). Connect the motherboard to the PC through usb, and the device manager of the PC can see the device

2. Enter the flashing step

1). Open the top cover of the device, unplug the battery at the device end, reconnect it, power off the device, and the power indicator light does not light up

2). Press and hold the button on the motherboard and connect the mini USB, only for 906Pro-660 models

3. Flash driver and flash tool installation

1). Unzip the flash driver and toolkit QPST_2.7.496.zip
2). Install the driver, click the option in the middle of Driver "Qualcomm USB Driver V1.0.exe" and click Next


3). Install the flashing tool, click “QPST.2.7.496.1.exe" and click next until the installation is complete

4). Open the flashing tool and enter qfil in the system search box

5). Wait for the port to display 9008, select as shown below

6). Select the program storage location

7). Load xml

7. Click download and release the button on the motherboard until Download success

4. NV configuration

1). Copy the NvConfigs directory in the firmware to the root directory of the TF card or U disk or push it to the /sdcard directory;

2). Open the serial number burning APP, click to write NV configuration

3). Check the corresponding NV, click OK, the device will restart automatically
4). After the writing is successful, the device will restart automatically (if there is a failure in the writing item, the device will not restart automatically)
5). After restarting, enter the management program interface, open the management program, click Settings > About, view the product name, and display the corresponding product