Autel IM608 Adds 2010 Chrysler Town & Country Keys

Autel MaxiIM IM608 did successfully pull the pin on a 2006 Dodge and I'm gonna show another 2010 Chrysler Town and Country.

Auto detect.

Auto scan VIN.
Chrysler (USA).

Diagnostic program loading.
Smart Mode.

Read the message.

Establishing vehicle communication.

Select "Smart Key".

Switch the ignition OFF and then ON again, make sure the engine is off.

Establishing vehicle communication.

The password is 3679.

Select "Read Immobilizer Password (CAN)".

Go to "Key Learning" again.
Tap "OK"
Establishing vehicle communication.

Learning failed.
I guess I should have the new key there.

Turn the ignition off and pull out the current key. Insert another key to be programmed, turn the ignition on, and make sure the engine has not been started.

Establishing vehicle communication.

Current number of keys is: 3
Learning successful.

I don't want to learn the next key, let's see if it works.

This is the new key, and I press the "Unlock button" it can start the car, nice.

This is the old key.

So. Success. As you can see, you did not need to connect the programmer, you can directly connect Autel IM608 to the Chrysler via OBD.

http://www.key-programmer.org/2020/02/24/2010-chrysler-town-country-add-keys-using-autel-im608/

Autel IM608 J2534 Write VIN to Ford used PCM Module

Vehicle model example:
Ford F-250 2001 super duty

Problem:
Not able to write VIN on the used PCM module after PCM replacement.

Device used to program:

Autel MaxiIM IM608 & MaxiFlash J2534 (The module is in default package)

Ford OEM subscription

FYI:

Normally IM608 alone can do this procedure.  All you need to do is click programming and look for a programmable module installation (PMI) which is a sequence in that the software will save all the original PCM’s information in IM608, then prompt you when to put the replacement module on it. Next it will then transfer all the information to the replace module.

With this vehicle 2001 F-250 it does not have this functionality on the IM608 so to do this procedure will be using J2534 with the OEM subscription. 

Procedure:

Go to Ford Diagnostic Menu->Auto Scan->Programming->Programmable Module Installation

The Autel IM608 does not have the “Programmable Module Installation” feature, use Ford’s OEM software to complete the programming task.

Purchase Ford day subscription from Ford Service Info website

Turn ignition to the OFF position

Run Ford OEM software

(* To write the VIN on a used module when original PCM is not present. Turn off the ignition when run the Ford software.)
Select vehicle year: 2001
Confirm vehicle information

Follow the prompt to Enter VIN
Insert VIN number and Tear Tag information

Note: Do not start a reprogramming session with a low battery in the vehicle and programming tool.
The fuel pump and the engine cooling fan(s) may run during the following procedure.
PCM reprogramming is in process

Then continue to follow prompts

Check VIN and insert mileage

Follow prompts until succeed.

Done.

www.obdii365.com

http://blog.obdii365.com/2020/02/19/program-ford-used-pcm-module-with-autel-im608-j2534/